Browsing by Author "Joubert, H. J."

Now showing 1 - 2 of 2
  • Thumbnail Image
    Item
    Investigating of eco- and energy-efficient lubrication strategies for the drilling of light metal alloys
    (Southern African Institute for Industrial Engineerg, 2010) Treurnicht, N. F.; Joubert, H. J.; Oosthuizen, G. A.; Akdogan, G.
    ENGLISH ABSTRACT: Energy use will be one of the main drivers for the achievement of more eco-efficient drilling processes in the automotive industry. Industry awareness of the environmental impact of used cutting emulsions, and the negative effect on worker health, has increased sharply. This has led to innovative lubrication methods such as through-spindle minimal quantity lubrication (MQL) for drilling aluminium-silicon alloys. In this work the performance of MQL at different cutting speeds and feed rates has been investigated using infrared temperature measurements. The results indicate that MQL is a feasible eco-efficient alternative to conventional flood cooling when drilling aluminium-silicon alloys.
  • Thumbnail Image
    Item
    Investigation of lubrication strategies in Ti6Al4V milling operations
    (Stellenbosch : Stellenbosch University, 2008-12) Joubert, H. J.; Treurnicht, N. F.; Stellenbosch University. Faculty of Engineering. Dept. of Industrial Engineering.
    There is a growing global demand for titanium. The aircraft industry is the driving force behind the demand for titanium. The reason for this is that titanium has attractive properties that justify its use both economically and environmentally. Titanium alloys have superior strength-to-weight ratios. This implies that by substituting components manufactured from other metals in the aircraft with titanium components, a substantial reduction in structural weight can be achieved. From an economical point of view a lower mass implies lower fuel consumption. From an environmental point of view lower fuel consumption implies less harmful greenhouse emissions. Ti6Al4V components are the most widely used titanium alloy products in aircraft components. Ti6Al4V is known as a difficult-to-machine material. This is due to its low thermal conductivity and small contact area between the tool and the chips causing higher temperatures to be generated closer to the cutting edge of the insert. This will subsequently increase the rate at which the cutting tool wears. For this reason relatively low cutting speeds and feed rates are employed for the machining of Ti6Al4V compared to the machining of steels. Ti6Al4V is an exceptionally high cost material. The low cutting speeds and feed rates used in Ti6Al4V machining raises the machining cost of parts and contributes to an increase in the price of Ti6Al4V parts. By employing higher cutting speeds and feed rates machining times on Ti6Al4V products could be decreased, subsequently lowering the price for Ti6Al4V components. An increase in cutting speeds and feed rates will subsequently cause an increase in generated cutting temperatures, resulting in an increase in tool wear. This stresses the importance of controlling the cutting temperature during machining of Ti6Al4V in order to prolong tool life. The focus of this work was to investigate different lubrication strategies for polycrystalline diamond (PCD) and tungsten carbide inserts for Ti6Al4V milling operations in the quest to develop improved feasible cutting parameters. The results of this study showed that flood lubrication should be utilized for PCD inserts, while a “softer” 60 bar high pressure through spindle lubrication worked best for the tungsten carbide inserts. By utilizing these lubrication strategies, cutting speeds of 100 m/min and feeds per tooth of 0.05 mm/rev for both the PCD and tungsten carbide grades could be attained with satisfactory tool life.