Masters Degrees (Civil Engineering)

Permanent URI for this collection

https://scholar.sun.ac.za/handle/10019.1/765

Browse

Browsing Masters Degrees (Civil Engineering) by Author "Adendorff, Christo Johan"

Now showing 1 - 1 of 1
  • Thumbnail Image
    Item
    The time-dependent cracking behaviour of strain hardening cement-based composite
    (Stellenbosch: University of Stellenbosch, 2009-12) Adendorff, Christo Johan; Boshoff, William Peter; University of Stellenbosch. Faculty of Engineering. Dept. of Civil Engineering.
    ENGLISH ABSTRACT: Strain Hardening Cement-based Composite (SHCC) is part of the High Performance Fibre Reinforced Cement-based Composite (HPFRCC) family and is a relative new concrete composite. This Fibre Reinforced Cement-based Composite (FRCC) contains randomly distributed short fibres and when subjected to a uni-axial tensile load multiple cracking occurs. The multiple cracking generates fine cracks which are normally smaller than 100 μm and achieve a strain capacity of more than 5 %. There are limited publications regarding the research of sustained tensile tests on SHCC and especially the cracking behaviour of SHCC under quasi-static uni-axial as well as sustained tensile loads. The cracking behaviour is described as the average crack width, number of cracks and descriptive statistical properties which could be used to represent the distribution of the multiple fine cracks under uni-axial tension. There are two types of tests that were under consideration to determine the cracking behaviour of SHCC. The first is quasi-static uniaxial tensile tests and the second is sustained tensile tests. The latter was dependant on the uni-axial tensile tests in terms of the sustained load applied. The sustained loads ranged from 40 % to 80 % of the ultimate tensile resistance recorded from the uni-axial tensile tests that correspond with a strain rate of 0.001 /s. Different strain rates were used for the uni-axial tensile tests to determine the effect on the cracking behaviour. The cracking behaviour was determined with the aid of a non-contact optical 3D digital deformation measuring device called ARAMIS. The content of this thesis gives a background study of the cracking behaviour and relevant research performed on SHCC under certain loads as well as some literature about the timedependant effects of a cement-based composite. The functioning of the device called ARAMIS is explained as well as the resulting effects of this device on the preparation of the test specimens. The experimental framework for the uni-axial and sustained tensile tests is discussed. Thereafter, the experimental results of the tests are depicted and discussed. The results shed some light on the basic material properties such as the average ultimate stress and average ultimate strain, Young’s modulus, etc. for the quasi-static tensile tests as well as shrinkage and creep of SHCC. The cracking behaviour such as the average crack width, number of cracks, the variance and skewness of the distribution of the crack widths in the test specimens for the quasi-static uni-axial and sustained tensile tests are depicted and discussed. The cracking behaviour when subjected to uni-axial tensile tests with different strain rates is significantly governed by the formation of new cracks and the average crack width remains small with increase in strain. There is no significant difference for the cracking behaviour found when subjected to different strain rates. However, when SHCC is subjected to a sustained load then the average crack width is dependant on the number of cracks that form over time as well as the load level. The formation of fewer and wider cracks was observed for specimens loaded at average 40 % of the ultimate tensile resistance stress, however at loading percentages of higher than 65 % more cracks developed which resulted in a smaller average crack width.