Department of Mechanical and Mechatronic Engineering

Permanent URI for this community

https://scholar.sun.ac.za/handle/10019.1/109

Browse

Browsing Department of Mechanical and Mechatronic Engineering by browse.metadata.type "Conference Paper"

Now showing 1 - 3 of 3
  • Thumbnail Image
    Item
    Communication in a LabVIEW based holonic controller
    (Faculty of Engineering, Department of Industrial Engineering, Stellenbosch University, 2016) Masendeke, D. M.; Basson, A. H.
    ENGLISH ABSTRACT: This paper presents a communication approach for a holonic controller developed in LabVIEW. The controller is aimed at station that forms part of a reconfigurable assembly cell. The objective of the research was to evaluate the extent to which LabVIEW facilitates reconfigurability in this context. The holons were implemented by using LabVIEW’s producer/consumer (to achieve asynchronous inter- and intra-holon communication) and state machine architectures. The paper discusses some implementation considerations. The paper shows that LabVIEW offers some attractive facilities for lower levels of reconfigurable control systems.
  • Thumbnail Image
    Item
    Investigating the energy efficiency and surface integrity when machining titanium alloys
    (Faculty of Engineering, Department of Industrial Engineering, Stellenbosch University, 2016) Tayisepi, N.; Laubscher, R. F.; Oosthuizen, G. A.
    Sustainable manufacturing strategies will need to address the resource efficiency and surface quality challenges in cutting processes. This paper aims to provide a systematic methodology for modelling the input and outputs of a turning process to find the best balance between production rate and input cost, while improving or adhering to the quality standards. Ti6Al4V were cut under flood cooling using carbide cutting tools and a Taguchi design of experiments was used with ANOVA. Surface integrity and energy use were measured and analysed for selected cutting parameters. The experimental results highlighted the importance of selecting optimum cutting parameters and machining strategy. More energy was consumed at lower cutting parameters, whilst higher feed rates resulted in less energy consumption, but lower surface finish quality. These results will also assist to define the boundary conditions for various input parameters.
  • Thumbnail Image
    Item
    Solution heat treatment of single crystal castings of CMSX-4 nickel-base superalloy
    (Faculty of Engineering, Department of Industrial Engineering, Stellenbosch University, 2016) Rzyankina, E.; Pytel, M.; Mahomed, N.; Nowotnik, A.
    An investigation of the microstructure and mechanical properties for heat treated directionally cast rods, produced from the nickel-based superalloy, CMSX-4, is presented. The rods were cast using the Bridgman method for manufacturing single crystal structures. The microstructure of the cast rods consists of γ and γ' precipitates. This microsegregation has a negative effect on the microstructure and, hence, the mechanical properties of the castings. The solution heat treatment of the second generation, single crystal Ni-base superalloy, CMSX-4, is known to dissolve the eutectic γ and γ' region. This requires temperatures up to 1316°C and approximately 45 hours total time. These high temperatures and long processing times result in high costs. The aim of this study is to investigate the effect of the heat treatment protocol on the extent of improvement of quality of single crystal castings, as a basis for determining cost feasibility in practice.